Bale dimensions: height 70cm width 120cm length from 1 mt to 2.6 mt

Standard equipment:
Check-in control box with bale counter, wide angle cardan shaft,, double wheel on the pick-up, pick-up with hydraulic raising, pressure gauge, lights, fans or binders, “autostart system for fans”, anomaly indicator for knotters .

Optional:
Hydraulic brake, air brake, last bale expeller, mounted bale stacker, pick-up plate for short hay.

Watch video:
Supertino SR 712
FEATURES
	The pick-up has two rubber wheels and functions hydraulically. The reduced diameter and the 2.2 mt width allow for perfect collection in wide paths and of short product.
	The five Rasspe knotters use twine of 130 to 150 m/Kg The two easy-access roll-holder compartments can hold 15 spools of twine. The three fans regulated intermittently by the check-in control box guarantee cleaning of the knotters. The bales are compressed by the four hydraulic cylinders which exercise a constant pressure on the sides and on the top of the channel, and a pressure gauge visible from the tractor cabin shows compression density. On request, a mounted bale stacker can be fitted in place of the bale unloading ramp; it can also be hydraulically tipped up to reduce length when on the road. Paired bales speed up loading operations.
	The control box installed in the tractor cabin allows for control of: - The arrival and maintenance of twine to the knotters, - bale unloading, - the knotting cycle - partial and total electronic bale counter, - binding anomaly indicator - automatic fan regulation.
	The double axle balance system (optional) has wheels 19.0/45-17 10PL.
	1. The rotary comb feeder conveys the product from the pick- up to the pre-chamber.
	2. The sensors located on the upper part of the pre-chamber, on achieving the set filling act to operate the mechanical system which begins the work cycle of the feeder fork and the opening of the straw-holder at the same time.
	3. The feeder fork at the same running stage of the piston feeds the pressing chamber as the piston is at the front dead point.
	4. By compressing the product the piston makes the feeder fork return to idle position and the straw stop devices engage ready for a new work cycle.

TECHNICAL DATA